KB-127166: Force value warnings

Force value warnings

To find out the force values in RSLogix 500, the following requirements need to be fulfilled.

If the use of force values has been activated in RSLogix 500 and your project contains force values, you will receive every time one or multiple warnings in the job event log

To open the job event log, proceed as follows

  1. Start the AdminClient.
  2. Go to Jobs.
  3. Go to the Home tab then to Job results.
  4. Click on Event log.

If you receive too many warnings that the force values have been identified, you can switch off this function in octoplant. To do this, you must change the value of the [RSLogix_PLC5] key in the UploadClasses.ini file.

Note

For individual jobs, you can deactivate this warning by clicking on Warn when forced values are active. This can be

found in the section RSLogix 500 settings.


Last update: September 15, 2023

Related Articles

IMPRINT | PRIVACY POLICY | COOKIE POLICY

Privacy Preference Center