KB-126887: Creating jobs

Creating jobs

The default network connections are the SSH connection and the TFTP connection.

In Job configuration, you can manage the ports for the connection setup. Only one switch can be accessed at a time via the TFTP port. If several switches are to be backed up simultaneously, you will need to set a different TFTP port for each switch. Here, it is important that you increase the maximum number of parallel uploads.

Creating jobs for PHOENIX CONTACT MGUARD router

  1. Start the AdminClient and open the Jobs module.
  2. In the Project tree, select the mGuard Switch component.
  3. In the menu tab, click on Create or drag and drop the components into the Jobs section.
  4. Check in the section Job configuration, if the upload type Switches is being displayed.

Note

  1. Under Upload and compare, set the Compare policy to Prev. backup <-> Backup, in case no project data in

the components was versioned. 1. Configure the section Switches settings:

Note

The standard TFTP port is 23. The standard SSH port is 22. 1. In Device, enter the IP address or name of the device that you want the job to access. 1. Under User, enter the user name under which the device is to be accessed. 1. In Password, enter the password of the corresponding user. 1. Set the Type to mGuard. 1. Enter the Port that you want to facilitate communication to the device.

  1. Configure the section, when needed, File specifications and compare settings by checking Enable custom configuration for this job.
  2. Save the job and execute it.

Last update: September 15, 2023

Related Articles

IMPRINT | PRIVACY POLICY | COOKIE POLICY

Privacy Preference Center